Coolant temperature indicator
With the engine running, when the needle is:
- in zone A , the temperature is correct,
- in zone B , the temperature is too high; the max temperature warning lamp 1 and the central STOP warning lamp come on, accompanied by an audible signal and a message in the screen.
You must stop as soon as it is safe to do so.
Wait a few minutes before switching off the engine.
Contact a PEUGEOT dealer or a qualified workshop.
After driving for a few minutes, the temperature and pressure in the cooling system increase.
To top up the level:
wait for the engine to cool,
unscrew the cap by two turns to allow the pressure to drop,
when the pressure has dropped, remove the cap,
top up the level to the "MAX" mark.
See also:
Direction indicators
Lower the lighting control stalk fully when moving to the left.
Raise the lighting control stalk fully when moving to the right.
If you forget to cancel the direction indicators for more than tw ...
Manual Check
This function allows you to check the status of the vehicle (reminder of the
active alert warnings) and the service information.
With the engine running, to start a manual check, briefly press ...
Speed limiter "LIMIT"
1. Limiter mode Selection / Off.
2. Decreasing the programmed value.
3. Increasing the programmed value.
4. Speed limiter On / Off.
The values must be set with the engine running. ...