Rear seats (308 saloon, 308 SW with bench rear seat)
Bench seat, the left-hand (2/3) or right-hand (1/3) section of which can be folded to adapt the boot load space.
Rear head restraints
These have a high position (comfort and safety) and a low position (rear visibility).
They can also be removed.
To remove a head restraint:
pull the head restraint fully forwards and upwards at the same time,
then, press the lug A
Never drive with the head restraints removed; they must be in place and in the high position when passengers are seated in the rear.
Removing the seat cushion
Move the corresponding front seat forwards if necessary.
Raise the seat cushion 1 lifting it with a hand from the rear.
Tilt the seat cushion 1 fully against the front seat.
Remove the seat cushion 1 from its fixings by pulling upwards.
Refitting the seat cushion
Position the seat cushion 1 vertically in its fixings.
Fold down the seat cushion 1 .
Press on the seat cushion to secure it.
Folding the seat
In order to fold a rear seat without any risk of damage, always start with the seat cushion, never with the seat back: move the corresponding front seat forwards if necessary,
raise the seat cushion 1 lifting it with a hand from the rear,
tilt the seat cushion 1 fully against the front seat,
check that the seat belt is positioned correctly on the side of the seat back,
lower or remove the head restraints if necessary,
pull the control 2 forwards to release the seat back 3,
tilt the seat back 3
Returning the seat back to its original position
When returning the rear seat back to its original position:
put the seat back 3 in the upright position and secure it,
fold the seat cushion 1,
refit the head restraints or put them back in place.
The seat cushion 1 can be removed to increase the loading volume.
When returning the rear seat back to its original position, take care not to trap the seat belts and ensure that their buckles are positioned correctly.
See also:
Running out of fuel (Diesel)
On vehicle fitted with HDi engines, the fuel system must be primed if you run
out of fuel; refer to the engine compartment view on the "Diesel engine" section.
If the tank on your vehicle ...
Operating fault
With the ignition on,
the flashing of this warning lamp and the flashing of AUTO , accompanied by an audible
signal and a message in the instrument panel screen, indicates a malfunction of
the ...
Displays in the instrument panel
The programmed information is grouped together in the instrument panel screen.
5. Cruise control off/resume indication.
6. Cruise control mode selection indication.
7. Programmed speed value.
8. ...