Locking the vehicle with full alarm system

Activation

Switch off the ignition and get out of the vehicle.

on the remote control.Press the locking button on the remote control.

 

is active: the indicator lamp in the button flashes once per second.The monitoring system is active: the indicator lamp in the button flashes once per second.

After the locking button on the remote control is pressed, the exterior perimeter monitoring is activated after a delay of 5 seconds and the interior volumetric monitoring after a delay of 45 seconds.

If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior perimeter monitoring will be activated after a delay of 45 seconds at the same time as the interior volumetric monitoring.

Deactivation

button on the remote control.Press the unlocking button on the remote control.

 

deactivated: the indicator lamp in the button goes off.The alarm system is deactivated: the indicator lamp in the button goes off.

 

    See also:

    Instrument panels
    On switching on, the dial needles go to the extent of their travel then return to 0. A. With the ignition on, the needle should indicate the fuel remaining. B. With the engine running, the assoc ...

    Interior
    Interior mood lighting This subdued passenger compartment lighting improves visibility inside the vehicle in low lighting conditions. It comprises several lamps, located below the instrument pa ...

    Identification markings
    Various visible markings for the identifi - cation and tracing of your vehicle. A. Vehicle identification Number (VIN) under the bonnet. This number is engraved on the bodywork near the damper suppo ...