Boot (308 SW with bench rear seat, 308 SW with individual rear seats)

 

Opening

Opening

After unlocking the vehicle using the remote control or the key, pull the handle and raise the tailgate.

Closing

Lower the tailgate using the interior grab handle.

If the tailgate is not closed correctly:

- when the engine is running , this warning lamp comes on, accompanied by a message

- when the engine is running , this warning lamp comes on, accompanied by a message in the multifunction screen for a few seconds,

- when the vehicle is moving (speed above 6 mph (10 km/h)), this warning lamp comes on, accompanied by an audible signal and a message in the multifunction screen for a few seconds.

Tailgate release

System allowing the mechanical unlocking of the boot in the event of a battery or central locking system malfunction.

Unlocking

Unlocking

Fold back the rear seats to gain access to the lock from inside the boot.

Insert a small screwdriver into hole A of the lock to unlock the tailgate.

Move the latch to the left.

Locking after closing

If the fault persists after closing again, the boot will remain locked.

    See also:

    Folding the backrest
    Move the front seats forward if necessary. Position the seat belts on the backrest and buckle them. Place the head restraints in the low position. Press both controls 1 simultaneously ...

    Peugeot 208 Allure e-HDi review
    Talking to Peugeot’s design chief, Gilles Vidal, makes you acutely aware of the importance of the 208, and it’s need to "re-generate" both Peugeot and, so it’s makers say, the small, B ...

    Ventilation
    Air intake The air circulating in the passenger compartment is filtered and originates either from the outside via the grille located at the base of the windscreen or from the inside in air rec ...