Rear lamps (308 SW with bench rear seat, 308 SW with individual rear seats)

1. Brake lamps / sidelamps (P21/5W).

1. Brake lamps / sidelamps (P21/5W).
2. Sidelamps (P21/5W).
3. Foglamp, offside (P21W)

Reversing lamp, nearside (P21W).

4. Direction indicators (P21W)

Changing bulbs

These five bulbs are changed from outside the boot:

open the boot,

unscrew the two lamp fixing bolts,

extract the lamp carefully pulling it from the bottom and pivoting it towards the outside,

unclip the lamp connector, separate the five tabs and remove the bulb holder,

unclip the lamp connector, separate the five tabs and remove the bulb holder,

turn the bulb a quarter of a turn and change it.

To refit, carry out these operations in reverse order.

To refit, carry out these operations in reverse order.

Take care to engage the lamp in its guides keeping it in line with the vehicle.

Changing the number plate lamp bulbs (W5W

Insert a thin screwdriver into one of the outer holes of the lens.

Insert a thin screwdriver into one of the outer holes of the lens.

Push it outwards to unclip.

Remove the lens.

Pull the bulb and change it.

Changing the third brake lamp (SW - 4 bulbs W5W)

Remove the two lamp fixing nuts A .

Remove the two lamp fixing nuts A .

Take out the lamp from the outside.

Disconnect the connector and the screenwash pipe from the lamp.

Turn the bulb holder corresponding to the faulty bulb a quarter of a turn.

Pull the bulb and change it.

To refit, carry out these operations in reverse order.

Do not force the lamp when tightening the nuts.

Changing the third brake lamp (SW - LEDs)

For the replacement of this type of LED lamp, contact a PEUGEOT dealer or a qualified

For the replacement of this type of LED lamp, contact a PEUGEOT dealer or a qualified workshop.

    See also:

    Towing your vehicle
    On the front bumper, unclip the cover by pressing at the bottom. Screw the towing eye in fully. Install the towing bar. Place the gear lever in neutral (position N on an electronic gearbox ...

    Manual guide-me-home lighting
    Temporarily keeping the dipped beam headlamps on after the vehicle's ignition has been switched off makes the driver's exit easier when the light is poor. Switching on With the ignition ...

    Child seat in the front
    "Rearwards-facing" When a "rearwards-facing" child seat is installed on the front passenger seat , it is essential that the passenger airbag is deactivated. Otherwise, the child ...