Fitting roof bars (308 SW with bench rear seat, 308 SW with individual rear seats)

When fitting transverse roof bars, ensure that they are positioned correctly as shown by marks under the longitudinal roof bars.
Use accessories recommended by PEUGEOT and follow the accessory manufacturer's fitting instructions.
In order to place a load on the roof, transverse roof bars must be fitted on the longitudinal roof bars.
After putting the load in place and securing it, retighten the transverse roof bars.
The longitudinal roof bars cannot
be removed.
Maximum authorised weight on the roof bars, for a loading height not exceeding
40 cm (except bicycle carriers): 75 kg.
If the height exceeds 40 cm, adapt the speed of the vehicle to the condition
of the road, to avoid damaging the roof bars and the fixings on the roof.
Be sure to refer to national legislation in order to comply with the regulations for transporting objects which are longer than the vehicle.
See also:
Engine oil level indicator
System which informs the driver whether the engine oil level is correct or not.
This information is indicated for a few seconds when the ignition is switched on,
after the service information.
Th ...
The peugeot 3008, a crossover available in a simple and clear range
According to countries, the Peugeot 3008 range will be available in four trim
levels. To offer the widest possible choice, it will be available in nine body
colours and, according to trim level, t ...
"Isofix" mountings
Your vehicle has been approved in accordance with the new ISOFIX regulation .
The seats, represented below, are fitted with regulation ISOFIX mountings:
The Isofix mountings are three rings fo ...






