Driver's electric seat

Seat consisting of a seat cushion, a seat back and a head restraint which can all be adjusted to adapt your position for ease of driving and comfort.

Forwards-backwards

Push the control forwards or rearwards to slide the seat.

Cushion height and angle

Cushion height and angle

Tilt the rear part of the control upwards or downwards to obtain the required height.

Tilt the front part of the control upwards or downwards to obtain the required angle.

The electrical functions of the driver's seat are active approximately

one minute after opening the front door. They are deactivated approximately one The electrical functions of the driver's seat are active approximately one minute after opening the front door. They are deactivated approximately one minute after the ignition is switched off and in economy mode.

To reactivate them, switch on the ignition.

Backrest angle

Tilt the control forwards or rearwards to adjust the angle of the seat back.

Head restraint height and angle adjustment

Head restraint height and angle adjustment

To raise the head restraint, pull it forwards and upwards at the same time.

To remove the head restraint, press the lug A and pull the head restraint upwards.

To put the head restraint back in place, engage the head restraint stems in the openings keeping them in line with the seat back.

To lower the head restraint, press the lug A and the head restraint at the same time.

To adjust the angle of the head restraint, tilt its lower part forwards or rearwards.

The head restraint is fitted with a frame with notches which prevents it

from lowering; this is a safety device in case of impact. The head restraint is fitted with a frame with notches which prevents it from lowering; this is a safety device in case of impact.

The adjustment is correct when the upper edge of the head restraint is level with the top of the head.

Never drive with the head restraints removed; they must be in place and adjusted correctly.

Manual lumbar adjustment

Turn the knob manually to obtain the desired level of lumbar support.

Heated seats control

Heated seats control

With the engine running, the front seats can be heated separately.

Use the adjustment dial, placed on the side of each front seat, to switch on and select the level of heating required:

0 : Off.
1 : Low.
2 : Medium.
3 : High.

Table position, front passenger seat

Table position, front passenger seat

Folding the seat backrest

Folding the seat backrest

Check that no object, either on or underneath the seat, could hinder its movement.

To make the operation easier, place the head restraint in the low position (if the seat is in the fully forward position).

If your vehicle is fitted with the video pack, place the protective cover on the head restraint.

Lift the control, located behind the seat, then guide the seat backrest forwards.

When the seat backrest is in this position, the seat behind it and the centre

When the seat backrest is in this position, the seat behind it and the centre rear seat must not be occupied.

This position, associated with that of the rear seats, allows you to transport long objects inside the vehicle.

The maximum weight on the seat is 30 kg.

Returning the seat to the normal position

Returning the seat to the normal position

Guide the seat backrest rearwards until it locks in place.

    See also:

    Grip control
    Special patented traction control system which improves traction on snow, mud and sand. This system is combined with all-season M+S (Mud and Snow: 215/60 R16) tyres which offer an excellent compr ...

    Driving advice
    Distribution of loads Distribute the load in the trailer so that the heaviest items are as close as possible to the axle and the nose weight approaches the maximum permitted without exceeding it. ...

    Diesel engines
    The various caps and covers allow access for checking the levels of the various fluids, for replacing certain components and for priming the fuel system. 1. Screenwash reservoir. 2. Coolant reserv ...