Doors

Opening

From outside

After unlocking the vehicle completely using the remote control or the key, pull

After unlocking the vehicle completely using the remote control or the key, pull the door handle.

From inside

Pull the door control (front or rear) to open the door; this unlocks this vehicle

Pull the door control (front or rear) to open the door; this unlocks this vehicle completely.

Closing The interior door controls do not operate when the vehicle is deadlocked.

Closing

When a door or the boot is not closed correctly:

warning lamp comes on, accompanied by a message in the multifunction screen for- When the engine is running , this warning lamp comes on, accompanied by a message in the multifunction screen for a few seconds,

- When the vehicle is moving (speed higher than 6 mph (10 km/h)), this warning lamp comes on, accompanied by an audible signal and a message in the multifunction screen for a few seconds.

Centralised locking control

System which provides full manual locking or unlocking of the doors from the inside.

Locking

Locking

Press this button to lock the vehicle.

The red indicator lamp in the button comes on.

take place. If one of the doors is open, the central locking from the inside does not take place.

Unlocking

Press this button again to unlock the vehicle.

The red indicator lamp in the button goes off.

When the vehicle is locked or deadlocked from the outside, the red indicator lamp When locking / deadlocking from the outside
When the vehicle is locked or deadlocked from the outside, the red indicator lamp fl ashes and the button is inactive.
After normal locking, pull the interior door lever to unlock the vehicle.
After deadlocking, it is necessary to use the remote control or the key to unlock the vehicle.

Automatic central locking

System which provides full automatic locking or unlocking of the doors and boot while driving, if they are closed correctly.

You can activate or deactivate this function.

Activation

Press this button for more than two seconds.

Press this button for more than two seconds.

by an audible signal. A confirmation message appears in the multifunction screen, accompanied by an audible signal.

Deactivation

Press this button again for more than two seconds.

A confirmation message appears in the multifunction screen, accompanied by an audible signal.

Locking

When the speed exceeds 6 mph (10 km/h), the doors and boot lock automatically.

If one of the doors is open, the automatic central locking does not take place.

If the boot is open, the automatic central locking of the doors is active.

Unlocking

Above 6 mph (10 km/h), press this button to unlock the doors and boot temporarily.

Emergency control In the event of an impact, the doors unlock automatically.

Emergency control

System which locks or unlocks the doors mechanically in the event of a malfunction of the battery or of the central locking.

In the event of a fault with the central locking, you must disconnect the battery to lock the boot and so ensure the complete locking of the vehicle.

Locking the driver's door

Insert the key in the lock, then turn it to the right.

Unlocking the driver's door

Insert the key in the lock, then turn it to the left.

Locking the front and rear passenger doors

Insert the key in the lock, located on the edge of the door, then turn it one

Insert the key in the lock, located on the edge of the door, then turn it one eighth of a turn .

Unlocking the front and rear passenger doors

Pull the interior door opening control.

    See also:

    General recommendations
    Observe the legislation in force in your country. Ensure that the weight of the towing vehicle is higher than that of the towed vehicle. The driver must stay at the wheel of the towed vehicle. Dri ...

    Automatic operation of hazard warning lamps
    When braking in an emergency, depending on the deceleration, the hazard warning lamps come on automatically. They switch off automatically the first time you accelerate. You can also switch them o ...

    Coolant temperature indicator
    With the engine running, when the needle is: - in zone A , the temperature is correct, - in zone B , the temperature is too high; the max temperature warning lamp 1 and the central STOP warnin ...