Hill start assist

System which keeps your vehicle immobilised temporarily (approximately 2 seconds) when starting on a gradient, the time it takes to move your foot from the brake pedal to the accelerator pedal.

This system only operates when:

- the vehicle is completely stationary, with your foot on the brake pedal,
- in particular conditions on a slope,
- with the driver’s door closed.

The hill start assist system cannot be deactivated.

On an ascending slope, with the vehicle stationary, the vehicle is held for

On an ascending slope, with the vehicle stationary, the vehicle is held for a momentarily when you release the brake pedal:

- provided you are in first gear or neutral on a manual gearbox,
- provided you are in position A or M on an electronic gear control gearbox,
- provided you are in position D or M on an automatic gearbox.

phase. Do not exit the vehicle while it is being held in the hill start assist phase.
If you need to exit the vehicle with the engine running, apply the parking brake manually then ensure that the parking brake warning lamp (and the warning lamp P in the lever of the electric parking brake) are on fixed (not flashing).

On a descending slope, with the vehicle stationary and reverse gear engaged,

On a descending slope, with the vehicle stationary and reverse gear engaged, the vehicle is held momentarily when you release the brake pedal.

Operating faults

If a fault in the system occurs, these warning lamps come on. Contact a PEUGEOT

If a fault in the system occurs, these warning lamps come on. Contact a PEUGEOT dealer or a qualified workshop to have the system checked.

If the electric parking brake fault warning lamp comes on together with one or more of the warning lamps presented in these tables, place the vehicle in a safe condition (on level ground, gear engaged) and contact a PEUGEOT dealer or a qualified workshop without delay.

Head-up display

    See also:

    Charging the battery using a battery charger
    Disconnect the battery from the vehicle. Follow the instructions for use provided by the manufacturer of the charger. Connect the battery starting with the negative terminal (-). Check that t ...

    6-Speed manual gearbox
    Engaging 5 th or 6 th gear Move the lever fully to the right to engage 5 th or 6 th gear. Engaging reverse gear Raise the ring under the knob and move the gear lever to the left then forwards. ...

    Stop & Start
    Going into engine STOP mode The "ECO" warning lamp comes on in the instrument panel and the engine goes into standby: - with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...