Folding the backrest
- Move the front seats forward if necessary.
- Position the seat belts on the backrest and buckle them.
- Place the head restraints in the low position.
- Press both controls 1 simultaneously to release the seat backrest 2.
- Fold the seat backrest 2 on to the cushion.
When folding the seat, the centre seat belt should not be buckled but laid out flat on the seat.
See also:
Stop & Start
Going into engine STOP mode
The "ECO" warning lamp
comes on in the instrument panel and the engine goes into standby:
- with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...
Travelling abroad
As Diesel fuel pump nozzles may be different in other countries, the presence
of the misfuel prevention device may make refuelling impossible. Before travelling
abroad, we recommend that you check ...
Engine oil level indicator
This information is displayed for a few seconds when the ignition is switched
on, after the service information.
The level shown will only be correct
if the vehicle is on level ground and the ...