Checking tyre pressures / inflating accessories
You can also use the compressor, without injecting any product, to:
- check or adjust the pressure of your tyres,
- inflate other accessories (balls, bicycle tyres...).
- Turn the selector A to the "Air" position.
- Uncoil the black pipe H fully.
- Connect the black pipe to the valve of the wheel or accessory. If necessary, fit one of the adaptors supplied with the kit first.
- Connect the compressor's electrical connector to the vehicle's 12 V socket.
- Start the vehicle and let the engine run.
- Adjust the pressure using the compressor (to inflate: switch B in position "I" ; to deflate: switch B in position "O" and press button C), according to the vehicle's tyre pressure label or the accessory's pressure label.
- Remove the kit then stow it.
See also:
Service overdue
For 5 seconds after the ignition is switched on, the spanner fl ashes to indicate
that the service must be carried out as soon as possible.
Example: the service is overdue by 186 miles (300 km).
F ...
Fitting roof bars
When fitting transverse roof bars, use the four quick-fi t fixings provided for
this purpose:
lift the concealing flaps, open the fixing covers on each bar using the key,
put each fixing in plac ...
Eco-driving
Eco-driving is a range of everyday practices that allow the motorist to optimise
their fuel consumption and CO2 emissions.
Optimise the use of your gearbox
With a manual gearbox, move off gently, ...