Closing
- Take the stay out of its support slot.
- Clip the stay back into its housing.
- Lower the bonnet and release it at the end of its travel.
- Pull on the bonnet to check that it has latched correctly.
See also:
Changing a wiper blade
Before removing a front wiper blade
Within one minute after switching off the ignition, operate the wiper stalk to
position the wiper blades vertically on the windscreen.
Removing
Raise the corre ...
Road-holding: the Marque's expertise
The Peugeot Marque has demonstrated the full extent of its expertise in
developing a new combination, at a very high level as regards the road-holding
of its Peugeot 208, in order to carry forward ...
Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does not block traffic: the ground must be level,
stable and not slippery.
Apply the parking brake, switch off the ignition and engage first gea ...