Rear lamps (308 SW with bench rear seat, 308 SW with individual rear seats)

1. Brake lamps / sidelamps (P21/5W).

1. Brake lamps / sidelamps (P21/5W).
2. Sidelamps (P21/5W).
3. Foglamp, offside (P21W)

Reversing lamp, nearside (P21W).

4. Direction indicators (P21W)

Changing bulbs

These five bulbs are changed from outside the boot:

open the boot,

unscrew the two lamp fixing bolts,

extract the lamp carefully pulling it from the bottom and pivoting it towards the outside,

unclip the lamp connector, separate the five tabs and remove the bulb holder,

unclip the lamp connector, separate the five tabs and remove the bulb holder,

turn the bulb a quarter of a turn and change it.

To refit, carry out these operations in reverse order.

To refit, carry out these operations in reverse order.

Take care to engage the lamp in its guides keeping it in line with the vehicle.

Changing the number plate lamp bulbs (W5W

Insert a thin screwdriver into one of the outer holes of the lens.

Insert a thin screwdriver into one of the outer holes of the lens.

Push it outwards to unclip.

Remove the lens.

Pull the bulb and change it.

Changing the third brake lamp (SW - 4 bulbs W5W)

Remove the two lamp fixing nuts A .

Remove the two lamp fixing nuts A .

Take out the lamp from the outside.

Disconnect the connector and the screenwash pipe from the lamp.

Turn the bulb holder corresponding to the faulty bulb a quarter of a turn.

Pull the bulb and change it.

To refit, carry out these operations in reverse order.

Do not force the lamp when tightening the nuts.

Changing the third brake lamp (SW - LEDs)

For the replacement of this type of LED lamp, contact a PEUGEOT dealer or a qualified

For the replacement of this type of LED lamp, contact a PEUGEOT dealer or a qualified workshop.

    See also:

    Rear head restraints
    These have one position for use (up) and a stowed position (down). They can be removed and are interchangeable side to side. To remove a head restraint: pull the head restraint upwards to the sto ...

    Temporary puncture repair kit (308 SW with bench rear seat)
    Complete system consisting of a compressor and a bottle of sealant which permits temporary repair of the tyre so that you can drive to the nearest garage. The kit is stowed in the boot storage ...

    Changing a wiper blade
    Before removing a front wiper blade Within one minute after switching off the ignition, operate the wiper stalk to position the wiper blades vertically on the windscreen. Removing Raise the cor ...