Automatic adjustment of the xenon headlamps

In order to avoid causing a nuisance to other road users, this system corrects

In order to avoid causing a nuisance to other road users, this system corrects the height of the xenon headlamps beam automatically and when stationary, in relation to the load in the vehicle.

If a malfunction occurs, this warning lamp is displayed on the instrument panel,

If a malfunction occurs, this warning lamp is displayed on the instrument panel, accompanied by an audible signal and a message on the multifunction screen.

The system then places your headlamps in the lowest position.

dealer or a qualified workshop. If a malfunction occurs, do not touch the xenon bulbs. Contact a PEUGEOT dealer or a qualified workshop.

    See also:

    Temporary puncture repair kit (308 SW with bench rear seat)
    Complete system consisting of a compressor and a bottle of sealant which permits temporary repair of the tyre so that you can drive to the nearest garage. The kit is stowed in the boot storage ...

    Stop & Start
    Going into engine STOP mode The "ECO" warning lamp comes on in the instrument panel and the engine goes into standby: - with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...

    Tyre under-inflation detection
    System which automatically and continuously checks the pressure of the tyres while driving. Sensors fitted in each valve trigger a warning in the event of problem (speed above 12 mph (20 km/h)) ...