Manual operation

  • Select position M for sequential changing of the four gears.
  • Push the lever towards the + sign to change up a gear.
  • Pull the lever towards the - sign to change down a gear.

It is only possible to change from one gear to another if the vehicle speed and engine speed permit; otherwise, the gearbox will operate temporarily in automatic mode.

appear in succession in the instrument panel. D disappears and the gears engaged appear in succession in the instrument panel.

If the engine speed is too low or too high, the gear selected flashes for a few seconds, then the actual gear engaged is displayed. It is possible to change from position D (automatic) to position M (manual) at any time. When the vehicle is stationary or moving very slowly, the gearbox selects gear M1 automatically.

The sport and snow programmes do not operate in manual mode.

Invalid value during manual operation

is not engaged correctly (selector between two positions). This symbol is displayed if a gear is not engaged correctly (selector between two positions).

    See also:

    Manual controls
    The wipers are controlled directly by the driver. Model without AUTO wiping Model with AUTO wiping Windscreen wipers Wiping speed: Rear wiper Rear wiper selection ring: park, intermi ...

    Warning lamps
    1. With the ignition on, the orange and red warning lamps come on. 2. With the engine running, these warning lamps should go off. If a warning lamp remains on, refer to the page concerned. ...

    Additional adjustments
    Head restraint height adjustment To raise the head restraint, pull it upwards. To remove the head restraint, press the lug A and pull the head restraint upwards. To put the head restraint back in ...