Stopping the vehicle
Before switching off the engine, you can engage position P or N to place the gearbox in neutral. In both cases, apply the parking brake to immobilise the vehicle.
If the lever is not in position P , when the driver's door is opened or approximately 45 seconds after the ignition is switched off, a warning message appears in the screen.
Return the lever to position P; the message disappears.
See also:
Driving advice
Distribution of loads
Distribute the load in the trailer so that the heaviest items are as close as
possible to the axle and the nose weight approaches the maximum permitted without
exceeding it. ...
Interior fittings
1. Glove box (see details on the following page)
2. Large storage compartment (without audio system)
3. 12 V accessory socket (120 W)
Observe the maximum power rating to avoid damaging your acces ...
Stop & Start
Going into engine STOP mode
The "ECO" warning lamp
comes on in the instrument panel and the engine goes into standby:
- with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...