Instrument panels

On switching on, the dial needles go to the extent of their travel then return to 0.
A. With the ignition on, the needle should indicate the fuel remaining.
B. With the engine running, the associated low level warning lamp should go off.

C. With the ignition on, the instrument panel screen should indicate the level of oil. If the levels are not correct, top up the level which is low.
See also:
Driving safely
Stop & Start
Going into engine STOP mode
The "ECO" warning lamp comes on
in the instrument panel and the engine automatically goes into standby:
- with a manual gearbox: at speeds ...
Visual and audible front and/or rear parking sensors
System consisting of four proximity sensors, installed in the front and/or rear
bumper.
It detects any obstacle (person, vehicle, tree, barrier...) located behind the
vehicle, however, it will ...
Boot
Opening
After unlocking the vehicle using the remote control or the key, press the handle
A and raise the tailgate
Closing
Close the lower tailgate.
Pull the handle B downwards to guide the ...






