Coolant temperature indicator

With the engine running, when the needle is:

With the engine running, when the needle is:

- in zone A , the temperature is correct,

- in zone B , the temperature is too high; the max temperature warning lamp 1 and the central STOP warning lamp come on, accompanied by an audible signal and a message in the screen.

You must stop as soon as it is safe to do so.

Wait a few minutes before switching off the engine.

Contact a PEUGEOT dealer or a qualified workshop.

After driving for a few minutes, the temperature and pressure in the cooling system increase.

To top up the level:

wait for the engine to cool,

unscrew the cap by two turns to allow the pressure to drop,

when the pressure has dropped, remove the cap,

top up the level to the "MAX" mark.

    See also:

    Oil filter
    Replace the oil filter each time the engine oil is changed. Refer to the servicing booklet for details of the replacement interval for this component. ...

    Trip reset
    When the trip required is displayed, press the control for more than two seconds or use the left hand thumb wheel of the steering mounted controls. Trips "1" and "2" are indep ...

    Removing a wheel
    Parking the vehicle Immobilise the vehicle where it does not block traffic: the ground must be level, stable and not slippery. Apply the parking brake, switch off the ignition and engage first gea ...