Locking the vehicle with full alarm system

Activation

Switch off the ignition and get out of the vehicle.

on the remote control.Press the locking button on the remote control.

 

is active: the indicator lamp in the button flashes once per second.The monitoring system is active: the indicator lamp in the button flashes once per second.

After the locking button on the remote control is pressed, the exterior perimeter monitoring is activated after a delay of 5 seconds and the interior volumetric monitoring after a delay of 45 seconds.

If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior perimeter monitoring will be activated after a delay of 45 seconds at the same time as the interior volumetric monitoring.

Deactivation

button on the remote control.Press the unlocking button on the remote control.

 

deactivated: the indicator lamp in the button goes off.The alarm system is deactivated: the indicator lamp in the button goes off.

 

    See also:

    Manual mode
    When the vehicle has moved off, select position M to change to manual mode. - Pull the lever towards the + sign to change up a gear. - Push the lever towards the - sign to change down a gear. The ...

    "Auto sequential" mode
    In the automated mode, you can resume control temporarily at any time using the steering mounted control paddles. The use of these paddles permits manual selection of the gears in situations whic ...

    Temporary puncture repair kit
    Complete system consisting of a compressor and a sealant cartridge which permits temporary repair of a tyre so that you can drive to the nearest garage. It is designed to repair most punctures whic ...