Reinitialisation of the electric windows

Following reconnection of the battery, the safety anti-pinch function must be reinitialised. The safety anti-pinch is not active during these operations:

- lower the window completely, then raise it, it will rise in steps of a few centimetres each time the switch is pressed. Repeat the operation until the window closes completely,
- press and hold the switch upwards for at least one second after reaching this position, window closed.

Always remove the key from the ignition when leaving the vehicle, even for a short time.

In the event of contact during operation of the windows, you must reverse the movement of the window. To do this, press the switch concerned.

When operating the passenger electric window switches, the driver must ensure that no one is preventing correct closing of the windows.

The driver must ensure that the passengers use the electric windows correctly.

Be aware of children when operating the windows.

    See also:

    Stop & Start
    Going into engine STOP mode The "ECO" warning lamp comes on in the instrument panel and the engine automatically goes into standby, with a 6-speed electronic gear control gearbox and a ...

    Monitoring
    Instrument panel A. With the ignition on, the needle should indicate the level of fuel remaining. B. With the engine running, its associated low level warning lamp should go off. C. With the igni ...

    Seat belts
    Front seat belts The front seat belts are fitted with a pretensioning and force limiting system. This system improves safety in the front seats in the event of a front or side impact. Depending o ...