Manual parking brake

Application

Application

Pull the parking brake lever up to immobilise your vehicle.

Release

Pull the parking brake lever up gently, press the release button then lower the lever fully.

being driven, if this warning lamp and the STOP warning lamp come on, accompanied When the vehicle is being driven, if this warning lamp and the STOP warning lamp come on, accompanied by an audible signal and a message in the screen, indicating that the parking brake is still on or has not been fully released.

When parking on a slope, direct your wheels against the kerb, apply the parking brake, engage a gear and switch off the ignition.

    See also:

    Coolant level
    The coolant level should be close to the "MAX" mark but should never exceed it. When the engine is warm, the temperature of the coolant is regulated by the fan. This can operate with th ...

    Temporary puncture repair kit
    Complete system consisting of a compressor and a sealant cartridge which permits temporary repair of a tyre so that you can drive to the nearest garage. It is designed to repair most punctures whi ...

    5-speed manual gearbox
    Engaging reverse gear Push the gear lever to the right then backwards. Only engage reverse gear when the vehicle is stationary with the engine at idle. As a safety precaution and to facilitate st ...