"Auto sequential" mode
In the automated mode, you can resume control temporarily at any time using the steering mounted control paddles.
The use of these paddles permits manual selection of the gears in situations which require a more rapid change-down than in the automated mode (arrival at a roundabout, leaving a car park with a steep gradient, overtaking...).
The gearbox engages the required gear if the engine speed permits. AUTO remains displayed on the instrument panel.
After a few moments, the gearbox resumes automatic control of the gears.
See also:
Operating fault
With the ignition
on, if this warning lamp comes on and AUTO flashes, accompanied by an audible signal
and a message in the screen, this indicates a gearbox fault.
Have it checked by a PEUGEOT d ...
Engine oil level indicator
This information is displayed for a few seconds when the ignition is switched
on, after the service information.
The level shown will only be correct if the vehicle is on level ground
and the ...
Parking lamps
Side markers for the vehicle by illumination of the sidelamps on the traffic
side only.
Within one minute of switching off the ignition, operate the lighting control
stalk up or down depending ...