Checking tyre pressures / inflating accessories
You can also use the compressor, without injecting any product, to:
- check or adjust the pressure of your tyres,
- inflate other accessories (balls, bicycle tyres...).
- Turn the selector A to the "Air" position.
- Uncoil the black pipe H fully.
- Connect the black pipe to the valve of the wheel or accessory. If necessary, fit one of the adaptors supplied with the kit first.
- Connect the compressor's electrical connector to the vehicle's 12 V socket.
- Start the vehicle and let the engine run.
- Adjust the pressure using the compressor (to inflate: switch B in position "I" ; to deflate: switch B in position "O" and press button C), according to the vehicle's tyre pressure label or the accessory's pressure label.
- Remove the kit then stow it.
See also:
Locking the vehicle with full alarm system
Activation
Switch off the ignition and get out of the vehicle.
Press the locking button
on the remote control.
The monitoring system
is active: the indicator lamp in the button flashes ...
Stop & Start
The Stop & Start system puts the engine temporarily into standby - STOP mode
- during stops in the traffic (red lights, traffic jams, or other...). The engine
restarts automatically - START mo ...
Cornering lighting
With dipped or main beams, this function makes use of the beam from a front foglamp
to illuminate the inside of a bend, when the vehicle speed is below 25 mph (approximately
40 km/h) (urban driv ...