Starting using another battery
- Connect the red cable to the positive terminal (+) of the flat battery A , then to the positive terminal (+) of the slave battery B.
- Connect one end of the green or black cable to the negative terminal (-) of the slave battery B.
- Connect the other end of the green or black cable to the earth point C on your vehicle (engine mounting).
- Operate the starter, let the engine run.
- Wait until the engine returns to idle and disconnect the cables.
See also:
Weights and towed loads (in kg) (2)
* The weight of the braked trailer can be increased, within the GTW limit, if
the GVW of the towing vehicle is reduced by an equal amount; warning, towing using
a lightly loaded towing vehicle m ...
Doors
Opening
From outside
After unlocking the vehicle completely using the remote control or the key, pull
the door handle.
From inside
Pull the interior control lever of a front door; this unloc ...
Warning lamps
1. With the ignition on, the orange and red warning lamps come on.
2. With the engine running, these warning lamps should go off.
If a warning lamp remains on, refer to the page concerned. ...