Closing

  • Take the stay out of its support slot.
  • Clip the stay back into its housing.
  • Lower the bonnet and release it at the end of its travel.
  • Pull on the bonnet to check that it has latched correctly.
    See also:

    Front demist - defrost
    These markings on the control panel indicate the control positions for rapid demisting or defrosting of the windscreen and side windows. With the heating / ventilation system Put the temperatur ...

    Stopping the vehicle
    Before switching off the engine, you can change to position N to be in neutral. In this case, you must apply the parking brake to immobilise the vehicle. ...

    Programming
    Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected but is not switched on (PAUSE). Set the programmed speed by accelerating to the required speed, then pre ...