Switching the engine off
- Immobilise the vehicle.
- Turn the key fully towards you to position 1 (Stop) .
- Remove the key from the ignition switch.
Free wheeling
For safety reasons, do not free wheel. If free wheeling, some vehicle functions will no longer be active.
A heavy object (key fob...), attached to the key and weighing down on its shaft in the ignition switch, could cause a malfunction.
Key left in the "Ignition on" position
On opening the driver's door, an alert message is displayed, accompanied by an audible signal, to remind you that the key is still in the ignition switch at position 1 (Stop).
If the key has been left in the ignition switch at position 2 (Ignition on), the ignition will be switched off automatically after one hour. To switch the ignition back on, turn the key to position 1 (Stop) , then back to position 2 (Ignition on).
See also:
Operating fault
In the event of a fault
with the sunshine sensor, the lighting comes on, this warning lamp is displayed
in the instrument panel and/or a message appears in the screen, accompanied by an
audible ...
Diesel weights and towed loads (in kg) - commercial vehicles
The GTW and towed load values indicated are valid up to a maximum altitude of
1 000 metres; the towed load mentioned must be reduced by 10 % for each additional
1 000 metres of altitude.
High a ...
Sun visor
Component which protects against sunlight from the front or the side, also equipped
with an illuminated courtesy mirror.
With the ignition on, raise the concealing flap; the mirror is lit automat ...