Stopping the vehicle

Before switching off the engine, you can choose to:

- move to position N to engage neutral,
- leave the gear engaged; in this case, it will not be possible to move the vehicle.

In both cases, you must apply the parking brake to immobilise the vehicle.

When immobilising the vehicle, with the engine running, you must place the gear lever in neutral N.

Before carrying out any work in the engine compartment, check that the gear lever is in neutral N and that the parking brake is applied.

    See also:

    Ventilation
    Air intake The air circulating in the passenger compartment is filtered and originates either from the outside via the grille located at the base of the windscreen or from the inside in air rec ...

    Speed limiter "LIMIT"
    1. Limiter mode Selection / Off. 2. Decreasing the programmed value. 3. Increasing the programmed value. 4. Speed limiter On / Off. The values must be set with the engine running. ...

    Stop & Start
    Going into engine STOP mode The "ECO" warning lamp comes on in the instrument panel and the engine goes into standby: - with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...