Hill start assist
System which keeps your vehicle immobilised temporarily (approximately 2 seconds) when starting on a gradient, the time it takes to move your foot from the brake pedal to the accelerator pedal.
This function is only active when:
- the vehicle is completely stationary, with your foot on the brake pedal,
- when certain conditions of gradient are met,
- with the driver’s door closed.
The hill start assist function cannot be deactivated.
Do not leave the vehicle while it is being held in the hill start assist phase. If you need to leave the vehicle while the engine is running, apply the parking brake manually then ensure that the parking brake warning lamp is on (not flashing) in the instrument panel.
See also:
Rear parking sensors
The system is switched on by engaging reverse gear. This is accompanied by an
audible signal. The system is switched off when you exit reverse gear.
Audible assistance
The proximity information ...
Access to the battery
The battery is located under the bonnet. To gain access to it:
open the bonnet using the interior release lever, then the exterior safety
catch,
secure the bonnet stay,
remove the plastic ...
Switch panel
Illumination of the lamp indicates the status of the corresponding function.
A. Deactivation of rear parking sensors.
B. Deactivation of the DSC/ASR system.
C. Deactivation of the Stop & Star ...