Fitting roof bars (308 SW with bench rear seat, 308 SW with individual rear seats)
When fitting transverse roof bars, ensure that they are positioned correctly as shown by marks under the longitudinal roof bars.
Use accessories recommended by PEUGEOT and follow the accessory manufacturer's fitting instructions.
In order to place a load on the roof, transverse roof bars must be fitted on the longitudinal roof bars.
After putting the load in place and securing it, retighten the transverse roof bars.
The longitudinal roof bars cannot
be removed.
Maximum authorised weight on the roof bars, for a loading height not exceeding
40 cm (except bicycle carriers): 75 kg.
If the height exceeds 40 cm, adapt the speed of the vehicle to the condition
of the road, to avoid damaging the roof bars and the fixings on the roof.
Be sure to refer to national legislation in order to comply with the regulations for transporting objects which are longer than the vehicle.
See also:
Cornering lighting
With dipped or main beams, this function makes use of the beam from a front foglamp
to illuminate the inside of a bend, when the vehicle speed is below 25 mph (approximately
40 km/h) (urban driv ...
Manual guide-me-home lighting
Temporarily keeping the dipped beam headlamps on after the vehicle's ignition
has been switched off makes the driver's exit easier when the light is poor.
Switching on
With the ignition ...
Identifi cation markings
Various visible markings for the identification of your vehicle.
A. Vehicle Identification Number (VIN) under the bonnet. This number is engraved
on the bodywork near the damper support.
B. Vehi ...