Directional lighting
When the dipped or main beam headlamps are on, this function enables the light beams to provide improved lighting of the side of the road when cornering.
The use of this function, from approximately 12 mph (20 km/h) and associated with the xenon headlamps only, considerably improves the quality of your lighting when cornering.
with directional lighting
without directional lighting
Programming
The function is activated or deactivated via the vehicle configuration menu.
Operating fault
If a fault occurs, this warning lamp fl ashes in the instrument panel, accompanied by a message in the screen.
Contact a PEUGEOT dealer or a qualified workshop.
When stationary or moving at very low speed or when reverse gear is engaged,
the function is inactive.
The status of the function remains in the memory when the ignition is switched off.
See also:
Changing a wiper blade
Before removing a front wiper blade
Within one minute after switching off the ignition, operate the wiper stalk to
position the wiper blades vertically on the windscreen.
Removing
Raise the corre ...
Stop & Start
Going into engine STOP mode
The "ECO" warning lamp
comes on in the instrument panel and the engine goes into standby:
- with a manual gearbox , at speeds below 12 mph (20 km/h), when you ...
Warning lamps
When the engine is running or the vehicle is being driven, illumination of one
of the following warning lamps indicates a fault which requires action on the part
of the driver.
Any fault resultin ...