Battery
Procedure for charging your battery when it is flat or for starting the engine using another battery.
The presence of this label indicates the use of a 12 V lead-acid battery with special technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is required when replacing or disconnecting the battery. Failure to observe this recommendation may cause premature wear of the battery.
After refitting the battery, the Stop & Start system will only be active after several hours depending on the climatic conditions and the state of charge of the battery (up to about 8 hours).
See also:
Operation
Anti-lock braking system (ABS) and electronic brake force distribution (EBFD)
When this warning lamp
comes on, accompanied by an audible signal and a message, it indicates that there
is a fault w ...
Stopping the vehicle
Before switching off the engine, you can engage position P or N to place the
gearbox in neutral. In both cases, apply the parking brake to immobilise the vehicle.
If the lever is not in position P ...
Optimised aerodynamics
The dimensions of the Peugeot 208, in particular the width (-2 cm) and the
height (-1 cm compared with the 207), its volumes which have been designed with
particular attention, the care given to e ...