1.6 litre HDi engine

  • Fill the fuel tank with at least five litres of diesel.
  • Open the bonnet.
  • If necessary, unclip the styling cover for access to the priming pump.
  • Squeeze and release the priming pump repeatedly until resistance is felt (there may be resistance at the first press).
  • Operate the starter until the engine starts (if the engine does not start at the first attempt, wait around 15 seconds before trying again).
  • If the engine does not start after a few attempts, operate the priming pump again then start the engine.
  • Clip the styling cover back in place.
  • Close the bonnet.
    See also:

    Operation
    Anti-lock braking system (ABS) and electronic brake force distribution (EBFD) When this warning lamp comes on, accompanied by an audible signal and a message, it indicates that there is a fault w ...

    Programming
    Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected but is not switched on (PAUSE). Set the programmed speed by accelerating to the required speed, then pre ...

    Petrol engines
    The various caps and covers allow access for checking the levels of the various fluids and for replacing certain components. 1. Power steering reservoir. 2. Screenwash and headlamp wash reserv ...