Safety anti-pinch
When the window rises and meets an obstacle, it stops and immediately partially lowers again. In the event of unwanted opening of the window when closing automatically, press the switch until the window opens completely, then pull the switch immediately until the window closes. Continue to hold the switch for approximately one second after the window has closed. The safety anti-pinch function is not active during this operation.
See also:
Programming
Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected
but is not switched on (PAUSE).
Set the programmed speed by accelerating to the required speed, then pre ...
Changing a wiper blade
Before removing a front wiper blade
Within one minute after switching off the ignition, operate the wiper stalk to
position the wiper blades vertically on the windscreen.
Removing
Raise the corre ...
Changing a fuse
Procedure for replacing a faulty fuse with a new fuse to rectify a failure of
the corresponding function.
Access to the tools
The extraction tweezer is fitted to the back of the dashboard fusebo ...