Changing a wiper blade
Before removing a front wiper blade
Within one minute after switching off the ignition, operate the wiper stalk to position the wiper blades vertically on the windscreen.
Removing
Raise the corresponding wiper arm.
Unclip the wiper blade and remove it.
Fitting
Put the corresponding new wiper blade in place and clip it.
Fold down the wiper arm carefully.
After fitting a front wiper blade
Switch on the ignition.
Operate the wiper stalk again to park the wiper blades.
See also:
Warning lamps
1. With the ignition on, the orange and red warning lamps come on.
2. With the engine running, these warning lamps should go off.
If a warning lamp remains on, refer to the page concerned. ...
Access to the tools
The towing eye is installed in the boot under the floor.
To gain access to it:
open the boot,
lift the floor and remove it,
remove the towing eye from the holder. ...
Temporary puncture repair kit
Complete system consisting of a compressor and a sealant cartridge which permits
temporary repair of a tyre so that you can drive to the nearest garage. It is designed
to repair most punctures whi ...