See also:

Programming
Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected but is not switched on (PAUSE). Set the programmed speed by accelerating to the required speed, then pre ...

Towing another vehicle
On the rear bumper, unclip the cover by pressing at the bottom. Screw the towing eye in fully. Install the towing bar. Switch on the hazard warning lamps on both vehicles. Move off gently ...

Monitoring
Instrument panel A. With the ignition on, the needle should indicate the level of fuel remaining. B. With the engine running, its associated low level warning lamp should go off. C. With the igni ...