Electric windows
System intended to open or close a window manually or automatically. Fitted with a safety anti-pinch system and a system for deactivation in the event of misuse of the rear controls.
1. Driver
2. Passenger
3. Rear right
4. Rear left
5. Deactivation of the rear electric windows and doors.
One-touch electric windows
Manual mode
Press or pull the control gently. The window stops when the control is released.
Automatic mode
Press or pull the control firmly. The window opens or closes fully when the control is released.
Pressing the control again stops the movement of the window.
The electric window controls remain operational for approximately 45 seconds
after the ignition is switched off or until the vehicle is locked after a front
door is opened.
If one of the passenger windows cannot be operated from the driver's door control
panel, carry out the operation from the control pad of the passenger door concerned,
and vice versa.
After approximately ten consecutive complete opening/closing movements of
the window, a protection function is activated to prevent damage to the electric
window motor.
After this, you have approximately one minute within which to close the window.
Once the window is closed, the controls will become available again after approximately
40 minutes.
Safety anti-pinch
When the window rises and meets an obstacle, it stops and partially lowers again.
If the window cannot be closed (for example, in the presence of ice), immediately after the movement is reversed:
Press and hold the control until the window opens fully.
Then pull the control immediately and hold it until the window closes.
Continue to hold the control for approximately one second after the window has closed.
The safety anti-pinch function is not operational during these operations.
Reinitialisation
If a window does not rise automatically, its operation must be reinitialised: pull the control until the window stops, release the control and pull it again, repeat these operations until the window closes fully, continue to hold the control for approximately one second after the window has closed, press the control to lower the window automatically to the low position, when the window has reached the low position, press the control again for approximately one second.
The safety anti-pinch function is not operational during these operations.
Deactivation of the rear electric windows and doors
For the safety of your children, with the ignition on, press control 5 to deactivate the rear electric window controls regardless of their position.
It is still possible to open the doors from the outside and operate the rear electric windows from the driver's control panel.
Indicator lamp on, the rear controls are deactivated.
Indicator lamp off, the rear controls are activated.
This control also deactivates the interior controls for the rear doors (see "Child lock").
Any other status of the indicator lamp indicates a malfunction of the electric
child lock.
Have it checked by a PEUGEOT dealer or a qualified workshop.
Always remove the key from the ignition when leaving the vehicle, even for a short
time.
If an obstacle is encountered during operation of the electric windows, you must
reverse the movement of the window. To do this, press the control concerned.
When the driver operates the controls for the passengers' electric windows, they
must ensure that no one is preventing correct closing of the windows.
The driver must ensure that the passengers use the electric windows correctly.
Be aware of children when operating the windows.
See also:
Visual and audible front and/or rear parking sensors
System consisting of four proximity sensors, installed in the front and/or rear
bumper.
It detects any obstacle (person, vehicle, tree, barrier...) located behind the
vehicle, however, it will ...
Electric child lock
Switching on
With the ignition on, press this button. The indicator lamp in the button comes
on, accompanied by a message to confirm that the child lock is on.
This indicator lamp remains on unt ...
Changing a wheel (308 SW with bench rear seat, 308 SW with individual rear
seats)
Procedure for changing a faulty wheel for the spare wheel using the tools provided
with the vehicle.
Access to the tools
The wheelbrace 1 is stowed in the boot left-hand side trim; for acces ...