Indicator and warning lamps
Visual indicators informing the driver that a system is in operation (operation or deactivation indicator lamps) or of the occurrence of a fault (warning lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the vehicle's ignition is switched on.
When the engine is started, these same warning lamps should go off.
If they remain on, before moving off, refer to the information on the warning lamp concerned.
Associated warnings
The illumination of certain warning lamps may be accompanied by an audible signal and a message in the multifunction screen.
The warning lamps may come on continuously (fixed) or fl ash.
Certain warning lamps may come on in one of two different modes. Only by relating the type of illumination to the operating status of the vehicle can it be ascertained whether the situation is normal or whether a fault has occurred.
See also:
Speed limiter "LIMIT"
1. Limiter mode Selection / Off.
2. Decreasing the programmed value.
3. Increasing the programmed value.
4. Speed limiter On / Off.
The values must be set with the engine running. ...
Direction indicators
Lower the lighting control stalk fully when moving to the left.
Raise the lighting control stalk fully when moving to the right.
If you forget to cancel the direction indicators for more than tw ...
Load reduction mode
System which manages the use of certain functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load reduction function temporarily deactivates
...